Showing posts with label led strips. Show all posts
Showing posts with label led strips. Show all posts

Thursday, 8 January 2015

LED's to light up your racer


It's always a good idea to put LED lights on your quad. I do it as I always get confused on which is front and back while flying some distance away. These LED lights are actually designed for a different frame, which also is a few bucks more than my shoestring budget QAV250 frame. The colors blue, white, green and red. The support 11V at 3S 14.8V at 4S. This package goes for $1.53 from good old Banggood.
I threaded the wires around the frame and through holes in order to get them away as good as possible as this frame does not contain soldering points and built-in power distribution.



Almost final assembly. I'm going to attach the lights under the frame or facing backwards so that they are visible from below. Not sure yet as attaching facing backwards will be an issue with the battery that also slides in from behind.







Have fun and let there be light!

Friday, 20 September 2013

A new era, a new beginning

It's been a while since my last post. The main cause is that I felt the energy drain as the fall gets more visible with worse weather, not too encouraging for quad flights. The darkness is also upon us, which makes flight difficult if it's not during day time.

As I've previously written, I ordered the radio telemetry, which I now got working. No hassle, it worked instantly. The only fault I did was to not turn down the COM-port speed from 115k to 57k, there after it worked as a charm :). The picture displays how the flight controller is connected to the laptop and Mission Planner using the radios. The radios are basically a wireless serial port.

Next, I focused on the darkness or rather how to fly when it's not full day light. Dusk has previously also been a hassle but these lights should mitigate that obstacle. Looking close at the picture below you can see how I wired the break out wire directly to the power distribution board. The board has tiny connectors all over, which allows soldering and therefore can provide extra connectivity as these lights require 11V.

Now to the final product, I started putting the quad back together, putting the lights in place. Hope this can light up any future winter flights.

I decided to go with green on the front and red on the back. Traditionally you should have green to the left and red to the right, but that doesn't help me when I usually see the quad from behind. Therefore I went with red to back and green up front.