RTL fly away...

Yesterday I went away to find a field large enough to do some serious RTL (return to launch) and navigation testing. This requires space without trees too close. I found some nice fields and started testing. I successfully tested both RTL and three way point navigation before my last RTL went sour...

I flew quite far away as I previously had done and hit the RTL. The normal procedure then is for the quad to gain height to 15 meters, which is default. Then head to its home position and descend to about 3 meters and loiter. This time, instead of turning towards home, it started drifting to the left. I quickly intervened to save the quad by counter steering rightwards. The quad then rotated 90-180 degrees making the direction impossible to see from this distance and disappeared behind those trees according to the drawing. I then ran towards the highway and never saw it again.

I've since then been covering the grounds around the point where it disappeared for about 8 hours in total, checking trees and the ground where it might have crashed without result.

It might have kept going in that direction ending up on the other side of the field as the program does not include anything about landing, but keeping 15 meters until the destination has been reached. It might also have taken a short trip on the field, then turned around ending up somewhere else. I still think the highest possibility is that it sitting in one of those trees along the highway.

Later today or tomorrow, I'm going to print posters asking people to contact me if they find my quad. Hope that gives some results. At this point, I don't think I can afford a new one, which leaves me with a pile of spare parts that will not be used..

The new propellers was a success

Last night I tried out the new 8 inch propellers along with a fresh motor to replace the last faulty one. The x550 now spins like a cat and flies like a bird. I trimmed the flight controller for the new propellers, which wasn't all that much to change and it's very stable.

After the basic trimming I started working on navigation and RTL (return to launch). These also has a set of P, I and D parameters for navigation. There is a good guide over at the ArduCopter wiki. However, I didn't have much success in trimming the RTL and the x550 always overshot or navigated wrong. Once both batteries were drained, I figured out that I'd trimmed using wrong parameters, dooh! I had been trimming the HLD_LAT/LON instead of LOITER_LAT/LON. Will have to do this at some other point where I can find a good field to try it out at.

Link to the guide: https://code.google.com/p/arducopter/wiki/AC2_loiter_PID

It became self aware

Someone once said: -"Pictures or it didn't happen".

This is how to get prepared for flight. In addition to the quad and the transmitter, you need a laptop.

Everything is by this time wired. That's why you see the green light on the flight controller. It indicates that the GPS reports that it is locked on to a fixed position. The sonar is also connected and reports correctly.

 

Another picture..

So, you wanna see how it flies :) ? The video is rather short due to two factors.

• The battery of my mobile was at this time drained to 4%, hence keeping it short.
• The left down motor gets seriously overheated due to some fault. It may break down if its magnets gets loose. This could happen due to heat as they are glued on...

 Note that I show no hands as the quad loiters :)